how to check ram slots using cmd

How to Check RAM Slots Using CMDChecking your RAM slots using the Command Prompt CMD is a quick and easy way to see how much RAM is installed and which slots are occupied. Heres how you can do it:1. Open Command Prompt: Press the Windows Key R on your keyboard, type cmd and press Enter.2. Run the Command: Type the following command and press Enter: wmic memorychip get banklabel, capacity, devicelocator, memorytype, speed, tag3. Analyze the Output: The output will display information about each RAM module installed in your system. Pay attention to the following columns: BankLabel: This indicates the slot number e.g., Bank 0, Bank 1. DeviceLocator: This provides a more specific location e.g., DIMM_A1, DIMM_A2. Capacity: This shows the size of each RAM module in MB. MemoryType: This identifies the RAM type e.g., DDR4, DDR3. Speed: This indicates the RAM speed in MHz.Example Output:BankLabel Capacity DeviceLocator MemoryType Speed Tag Bank 0 16384 DIMM_A1 DDR4 2133Bank 1 16384 DIMM_A2 DDR4 2133In this example, the output shows that two RAM modules are installed, both with a capacity of 16 GB 16384 MB and located in slots DIMM_A1 and DIMM_A2. Both modules are DDR4 and operate at a speed of 2133 MHz.Note: The output may vary depending on your system configuration.By using this command, you can easily identify which RAM slots are occupied and what type of RAM is installed in your computer. This information can be helpful for upgrading your RAM or troubleshooting any issues related to your systems memory.